Omnivex legacy products are considered feature complete and will not receive additional functionality. In most cases these products have been replaced by other products; customers with annual maintenance and support (AMS) can migrate to the new product based on their existing license. Omnivex supports these products under our AMS program. Listed below is the most recent version of each Omnivex legacy product and their supported operating systems. The information below is subject to change. This article is regularly updated.
Typically Omnivex applications use TCP/IP for communications. The following table describes the TCP/IP port used by each Omnivex application unless you specify a different port number to be used. If you are running the applications on a single computer, typically no additional configurations are necessary.
A typical Omnivex Moxie network is set up on three or more PCs, although all of the applications can be installed and run on a single PC or each on a different PC. Omnivex software can be divided into three general categories:
Typically, each category of application is installed on a different PC on the network.
Omnivex Control Director has built-in manufacturer's device control functions. There is no need for any programming if you are using a supported device in Server mode. Select your device using the Devices Setup wizard and all the command functions for the specified device are available in the software. For unsupported devices, commands can be manually created using Independent mode.